Materials for making 2 Signal Driver Cables for SE8C. Includes 30’of 10-wire Signal Driver ribbon cable & 8 10-Pin sockets.
Use this kit to make signal driver cables to connect your SE8c to the signals on the railroad. Make the cables any length that you desire and place the signal connectors at the locations where you will install signals. All the signals are carried neatly in the ribbon cable so you can avoid a “bird’s nest” under your layout.
245-BD4N
Digitrax BD4N DCC 4-Block Occupancy Detector
245-BD4
Digitrax BD4 Quad Occupancy Detector -- 4 Detection Sections, Outputs For Panel Mounted LEDs, For Use w/DS54 or SE8C
245-RX4
Digitrax RX4 Block Transponding Receivers -- 4-Block Unit
Copyright 2022 Hiawatha Hobbies All Rights Reserved.